01-11-2022 10:50 PM
Hi...
I have a vWLC and have 3 Access Points AIR-AP1832I-E-K9 and work in flexconnect mode and every things work fine, upline between APs and switch are trunk and native vlan are same.
But after reboot vWLC all of APs not accessible, I should ping them from vWLC and then accessible in Wireless tab
I don't know what is this issue...!
Regards
01-12-2022 06:43 AM
Hi
Have a look on the WLC time and time zone. This may changed on the reboot.
01-14-2022 10:33 PM
Hi,
I have NTP in my network and all of them are sync but I checked again and after reboot happened
Thank You,
01-17-2022 03:44 AM
Did you check which mode (flex, local etc.) the AP's are reporting to WLC? As you correctly identified vWLC supports only Flexconnect. May be due to configuration not saved or config corruption AP might have reverted back to local mode. So if thats the case revert it back to flex connect and it should start broadcasting SSD's.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: