AIR-AP1815I Stop message in the console

[walidit01]

Hello,

I want to configure the Cisco AIR-AP1851I, but it keep displaying those messages: 

[*01/10/2019 22:53:56.6099] Resetting wired0, ifconfig down up
[*01/10/2019 22:53:56.6099]
[01/10/2019 22:53:58.6299] IPv6: ADDRCONF(NETDEV_UP): wired0: link is not ready
[*01/10/2019 22:54:02.7099] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:07.7099] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:12.7199] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:13.7199] Resetting wired0, ifconfig down up
[*01/10/2019 22:54:13.7199]
[01/10/2019 22:54:15.7399] IPv6: ADDRCONF(NETDEV_UP): wired0: link is not ready
[*01/10/2019 22:54:19.8199] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:24.8199] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:29.8199] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:30.8199] Resetting wired0, ifconfig down up
[*01/10/2019 22:54:30.8199]
[01/10/2019 22:54:32.8499] IPv6: ADDRCONF(NETDEV_UP): wired0: link is not ready
[*01/10/2019 22:54:36.9199] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:41.9299] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:46.9299] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:47.9299] Resetting wired0, ifconfig down up
[*01/10/2019 22:54:47.9299]
[01/10/2019 22:54:49.9499] IPv6: ADDRCONF(NETDEV_UP): wired0: link is not ready
[*01/10/2019 22:54:54.0299] Waiting for uplink IPv4/IPv6 configuration
[*01/10/2019 22:54:59.0299] Waiting for uplink IPv4/IPv6 configuration

There is a command to stop those message ? 

Thank you !

[Sandeep Choudhary · Accepted solution]

Hi,

Try this command:

logging console disable

Regards

Dont forget to rate helpful posts

[walidit01]

Thank you Sandeep,
now i can see only few message like
AP70EA.1ADB.CCD8#[01/11/2019 00:34:06.9899] IPv6: ADDRCONF(NETDEV_UP): wired0: link is not ready
but the command is helpful.
Big thanks !