We use a 2960X-48 switch with ten AIR-AP2702I-B-K9. In the wlc eight show up with PoE/Medium Power (15.4 W) two PoE/Full Power.
Switch allows 30w on every port. CDP is enabled. Any idea what could be the cause?
We have other switches with all APs running full power, and some switches where one out of 10 runs 15.4w.
Thanks in advance.
Go to Solution.
Set the power static max by using command "power inline static max XX"
Dont forget to rate helpful posts
View solution in original post
We did not set power inline to static but rebooted the APs. Now they are all full power.
Thank you anyway!
Glad that you resolved the issue.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: