cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

AIR-AP3802E-B-K9 unable to join the wireless controller

ugwuugochukwuk
Beginner
Beginner

Hello All,

 

I have an ap model of AIR-AP3802E-B-K9 which cannot join the WLC, I have performed reset on the AP and yet it does not join the controller. It picks an IP address but registering to the WLC is the issue.

 

I have attached the log from the AP.

 

Thanks in anticipation!!!

9 REPLIES 9

Flavio Miranda
Advisor
Advisor

You problem is this:

 

"Max retransmission count exceeded, going back to DISCOVER mode."

This can be recheability problem. Make sure links is Ok.

Hello Flavio,

 

The link is OK

jagan.chowdam
Participant
Participant

Also, Can you share

1. WLC: sh sysinfo;
2. WLC: sh time;

 

Verify

  • Country Code is accurate
  • NTP is configured

Put the AP on the same VLAN as WLC and check

 

CJ

/**Please rate useful responses**/

 

 

patoberli
VIP Advisor VIP Advisor
VIP Advisor

The -B AP variant is a bit newer than the -A variant, both are for Americas (I think North America only). So which software release is running on the WLC?

Hello Patoberli,

 

The WLC runs software version 8.5.140.0.

 

Regards,

rrudling
VIP Advocate VIP Advocate
VIP Advocate
CAPWAP detected next hop MAC changed from 0007.B400.0E01 to 0007.B400.0E02

Unstable WAN link switching between primary and backup routers maybe, or duplicate IP configured? 

Hello rrudling,

 

The WAN link is stable, More than 3 Access points have registered with the controller since then. I don't think it's a WAN link issue.

 

Thanks 

Well then why is the AP detecting the next hop MAC address changing?

What is the Controller model? 

Did you set the dhcp option 43 correctly with the WLC IP?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: