Hello,
As part of a pre-requisite of potential project to deploy Teleworker AP's in remote locations I have configured a 2602 AP to be in OEAP mode for testing purposes. With anchoring setup the remote AP does successfully associate with the anchor WLC, however, I cannot see the anchored ssid remotely that I need to access.
A specific AP Group "OEAP" has been configured on the anchor WLC and the remote AP is a member of this group. The required WLAN has also been added to this group. I still cannot see the ssid though..
WLC: AIR-CT5508-K9
SW: 8.0.140.0
Any help/advice would be greatly appreciated.