11-28-2021 11:28 AM
hello,
the ssid is hidden on my AP AIR-CAP702I-E-K9, can any one tell me how to make it visible.
thank you
11-28-2021 02:04 PM
If the AP is being managed from a controller.
WLANs tick the box broadcast SSID enabled.
If you have an autonomous mode AP then:
you need command:
mbssid guest-mode - if you have multiple SSIDs or ssid guest-mode in the dot11 ssid config part
11-28-2021 11:21 PM
11-29-2021 01:41 AM
Hi,
If you are single ssid on AP then do these:
Conf ter
Dot11 ssid <SSID name>
Guest-mode
Regards
Dont forget to rate helpful posts
11-29-2021 02:58 PM
If its only a single SSID your trying to do.
On Capture 4.
Where it says Set Single Guest Mode SSID and the drop down box is <None> change that to your SSID
otherwise on capture 3. Under multiple BSSID Beacon Settings:
Tick Set SSID as Guest Mode then in capture 4 for the set beacon select Multiple BSSID.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: