09-23-2020 10:17 AM - edited 07-05-2021 12:33 PM
Hi all,
Can you please tell me the CLI command to check what is the SFP model connected to the WLC. The WLC model is
AIR-CT7510-K9.
09-23-2020 11:30 AM
Try below command
show inventory raw | in SFP-
https://mrncciew.com/2014/08/18/wlc-sfp-info/
HTH
Rasika
*** Pls rate all useful responses ***
09-23-2020 07:53 PM
I tried this. I don't get any result
(Cisco Controller) >show inventory raw | in SFP-
Incorrect input! Use 'inventory'
(Cisco Controller) >
09-23-2020 08:11 PM
Sorry, I read it as 5760.
If it is AireOS, you can try the below command. Refer that blog post
(Cisco Controller) >debug fastpath cfgtool --dump.sfp
HTH
Rasika
*** Pls rate all useful rate ***
09-23-2020 09:44 PM
(Cisco Controller) >
(Cisco Controller) >debug fastpath cfgtool --dump.sfp
(Cisco Controller) >FP0.
FP0.
Port SFP Vendor Transceiver Type OUI PartNumber Rev SerialNumber DateCode Auth
1 Not Present (0x00)NOT_SUPPORTED fail
2 Not Present (0x00)NOT_SUPPORTED fail
(Cisco Controller) >
(Cisco Controller) >
I get this above result.. does it mean there is no SFP here? this is a 7510 model and sfp ports.
09-24-2020 08:24 AM
Could also mean it's not a Cisco SFP. If you can go on-site and you have an active LAG / Etherchannel, you might simply unplug one and check it.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: