03-05-2012 08:06 AM - edited 07-03-2021 09:43 PM
hello,
I have a air-lap1042-n-e-k9, how to put this wi-fi mode autonomous ?
Thanks
03-05-2012 08:21 AM
03-05-2012 11:47 AM
03-05-2012 01:27 PM
I use a POE switch, because I don't external power ...
Same thing. You can disconnect the ethernet cable to power off the WAP or you can use the command in the interface-level "no power inline" or "power inline never" to disable power to the port.
03-06-2012 04:27 AM
Hello,
I did as in the link but its not working ...
Can you give me more explication.
Thanks
03-07-2012 01:19 PM
1. Connect the WAP into, say, port 1 of the Cisco switch.
2. Connect the TFTP server to say, port 2 on the Cisco switch.
3. Make sure they are on the same VLAN, VLAN 1, for example.
4. In the switch, configure this:
conf t
interface f0/1
power inline never
5. Hold down the WAP's "mode" button
6. Back to the switch, enter the command: no power inline never
7. Keep holding the mode button until it'll say something like "waiting for the mode button to be released" or something.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide