AIR-SAP2602 Cannot Config using GUI Before Factory Reset

[crooked9669]

Hey Guy,

My AIR 2602 cannot going to GUI using default IP 10.0.0.1 before facetory reset using Mode Button, anh I try to config AP using Console but it show mode I had nerver seen before.At this time I dont know how to config this AP.

Someone can help me ?

[Scott Fella]

Please post the output from the console so we know what you are referring to.

[Haydn Andrews]

the AP is in ROMMON mode

either the AP is missing its image, or just needs to be booted

If the image is still on it you can boot it via this command:

ap:boot flash:/<image name>

if you dont know the image name you can try:

ap: flash_init

ap: dir flash:

then use the boot command.

if the image is missing you need to TFTP one to the AP, you can either set all the details into ROMMON like IP etc or use the mode reset button option.

useful posts here to help get the image to the AP:

https://community.cisco.com/t5/wireless-mobility-documents/access-point-rommon-recovery-ap-prompt-recovery-example/ta-p/3119495

Details on the mode reset option in this post

https://thewlan.com.au/2016/09/27/configuring-a-cisco-ap-for-site-survey/

[crooked9669]

Your answer is very helpful, thanks you so much but now I can not detect the Image file name to boot, I can show you the command show to see :

ap: dir flash:
Directory of flash:/

2 -rwx 90 <date> env_vars

ap: fs_show

File Sys 0 - magic:06020248 devices:1 blks:249/252 avail:0 rdy:1

ap: flash_init
Initializing Flash...
...The flash is already initialized.

Try boot many time but no result

[Haydn Andrews]

looks like you will have to tftp the new image onto the AP to fix it.