Hello,
1. I am trying to configure 2802i using WLC3504. I connected the access point to the PoE port on the controller. I can see the access point mac id and the connected port number in Wireless-> Access points -> Direct APs.
But when I go to WLANs - > Advanced - > AP groups -> <My group> -> APs I don't see the access point there to add to the group.
Are there any extra steps that have to be performed here to see the AP?
2. I tried connecting the access point to using DB9 to RS232 serial cable (Speed: 9600, Data: 8 bits, parity: none, stop bits: 1bit, Flow control: none). The connection is established, but I don't see any prints from the access point.
Can someone please help me with this?
Thank you,
Sai.
