ā07-26-2021 06:55 AM
Two C9800s work as HA. Please see the below picture. In one of the two wlc, number 15 light is off and is red on the second wlc. Number 15 is "Alam LED" based on the description. Do you think its normal? why it happen? Thank you
Solved! Go to Solution.
ā07-26-2021 07:05 AM
You can issue the below command to check why the error is there
show facility-alarms status
My guest is that you have some ports which are in no shut status, but nothing is physically connected to the port. This alarm should disappear as soon as you shutdown the ports which are not in use.
ā07-26-2021 06:59 AM
- Attach a console , and or power cycle, the content of the alarm should be displayed on the console.
M.
ā07-26-2021 07:05 AM
You can issue the below command to check why the error is there
show facility-alarms status
My guest is that you have some ports which are in no shut status, but nothing is physically connected to the port. This alarm should disappear as soon as you shutdown the ports which are not in use.
ā07-26-2021 07:06 AM - edited ā07-26-2021 07:07 AM
Red |
Controller error. For example, a temperature error exists.
|
what speed this device connected, also look at the switch side and also connect console and check what is the error ?
from GUI check logs :
ā07-26-2021 07:30 AM - edited ā07-26-2021 07:33 AM
Yes, after shut down the interface, the alarm disappear and the lights(in both wlc) are off. Thank you Arshadsaf and all.
BTW, is there any difference between light 14 and 16? Both are for HA
ā07-26-2021 07:56 AM
Nice to know all good, we mark as resolved now.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: