ā12-08-2010 09:47 PM - edited ā07-03-2021 07:31 PM
Recently I config a 1142 with local authentication,and I read the configuration doc of the 1142 , I config the ap with eap-fast but when I assosiat with the ap , the alert is pop-up-there is no trust certificat.so I download the PAC file ,but I don't know how to change the PAC file to a cer file.somebody can told me how to config the eap-fast with local authentication.
ā12-08-2010 09:53 PM
Hi,
here is the link to configure the LOCAL radius on the AP with EAP..
we need to generate PAC.. here is the link to generate or Use the PAC
lemme know if this helps..
Regards
Surendra
======
Please dont forget to rate the post if this answered your question or was helpful
ā12-08-2010 10:00 PM
I will try it again ,thanks for your
link.
ā12-08-2010 10:04 PM
Ok.. No problem!! lemme know how this works out for you!!
Regards
Surendra
======
Please dont forget to rate the post if this answered your question or was helpful
ā12-09-2010 05:56 PM
did that work??
Regards
Surendra
===
Please rate the posts which answered your quiestion or was helpfull
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide