07-15-2012 10:17 AM - edited 07-03-2021 10:24 PM
Dear All,
we are using wism 4404 code 4.2 , we are using this old code becuase of 1250 mesh APs, now when a user connect to our network and he is using intel proset software he can see details of our AP, like mac, type and AP ip address 9 which in this case it the controllers ip address) is there a way we can prevent the ap from showing it?...we will be doing an upgrade to 7.0.230 soon. will the upgrade takes care of this problem or there is a way to fix it.
thanks a lot you guys
07-15-2012 10:37 AM
Disable aironet ie in the WLAN SSID advanced tab. That should do it.
Sent from Cisco Technical Support iPhone App
07-15-2012 03:14 PM
we will be doing an upgrade to 7.0.230 soon.
Go to 7.0.235.0 instead.
07-15-2012 09:35 PM
Thanks guys for the quick reply,
i disabled the Aironet IE for the ssid, and only the AP name disappeard but not the IP address, also we have a teat controller that runs code 7.0.230 and its doing the same thing, were i can see the ip address , but not the AP name.
any fix for this.?
Thanks and regards.
07-16-2012 07:24 PM
is the issue specific to guest wlan using anchor wlc or on all ssids.
07-17-2012 05:38 AM
Hi,
Its for all SSIDs
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide