04-24-2018 06:26 PM - edited 07-05-2021 08:33 AM
Hello!
What is the recommended WLC version in an scenario that currently has WLC 5508 and will add APs model 1562e to set up point to point links between sites? It will be operating as a WGB between sites.
Any help is appreciated!
04-24-2018 06:46 PM - edited 04-24-2018 06:48 PM
Latest 8.3 or 8.5.
NOTE: 8.5MR3 is scheduled for release by the end of April 2018.
04-24-2018 06:48 PM
Hi Genaro,
1562 works as mobility express or lightweight.
You can't use it as WGB.
You can make this as bridge AP.. (MAP or RAP)
Controller should be on 8.5.X version. 8.3 doesn't support Mesh fro 1560 models.
******Please rate Useful posts************
Regards,
Vengat
05-02-2018 08:29 AM
Thanks Vengat. The customer wants to connect remote sites through a wireless point to point bridge so WGB would have been my first solution.
With lightweight mesh APs are there any considerations for ethernet bridging? The MAP would connect to a switch through a trunk link to connect endpoints between sites.
09-12-2019 11:28 AM
Hi Experts.
We are currently proposing AP1562E but 2 of them will work in mesh mode,
We have a WLC 5508 with version 8.5.131, within this version of code does it support the configuration of Mesh? Have a Master and the other Access Point take a sign of this?
Anyone know anything about it.
Regards.
Carlos P.
09-12-2019 06:48 PM
hello Carlos,
I hope you are doing great!
the 8.5 release supports mesh mode for the AP 1560, you can verify that information on the code release node: https://www.cisco.com/c/en/us/td/docs/wireless/controller/release/notes/crn85mr3.html#ap-wave2
you will find that it shows mesh mode Supported on 1540 and 1560 APs.
09-13-2019 08:37 AM
09-13-2019 09:49 AM - edited 09-13-2019 09:51 AM
Hello Carlos,
I hope you are doing great!
yes, it is possible to extend the network through the MESH APs. For the distance between the RAP (Root AP) and MAP (MESH AP) your limit is 304 meters so 60 are more than ok.
I would recommend you to check the two mesh configuration guides on the links below:
https://www.cisco.com/c/en/us/td/docs/solutions/Enterprise/Mobility/emob41dg/emob41dg-wrapper/ch8_MESH.html
https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-5/Enterprise-Mobility-8-5-Design-Guide/Enterprise_Mobility_8-5_Deployment_Guide/Chapter-8.html
It seems that the AP 1560 does not support flex + mesh according to the chart on the picture below (i got the chart from the links above):
You would need to use another AP model to use that mode.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: