07-02-2021 03:03 PM - edited 07-02-2021 09:38 PM
Hello,
I have attached a camera to a mesh1572 AP and low and behold the camera picked up an IP and I can actually see video. It's in the wrong VLan and I would like to change that, but I can't find the actual port. All gig interfaces I can list on the AP show down
GigabitEthernet0 unassigned NO unset up/down
GigabitEthernet1 unassigned NO unset up/down
GigabitEthernet2 unassigned NO unset up/down
GigabitEthernet3 unassigned NO unset up/down
GigabitEthernet4 unassigned NO unset up/down
The interfaces all so show no traffic?
So i was wondering where the port is in the AP CLI or on the 9800 WLC it's connected to? How do I address this port?
Thanks
07-02-2021 11:09 PM
- You may try to disconnect and re-connect the camera , then immediately check the logs ,perhaps the port will be identified.
M.
07-05-2021 03:44 PM
Is the camera directly connected to the MAP? Is it by any chance getting the AP management VLAN ID or the native VLAN ID?
Have you got VLAN transparent configured or not?
To use VLAN tagging, you must uncheck the VLAN Transparent check box.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide