Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
680
Views
0
Helpful
1
Replies

AP 1700 autonomous ClientLink

Go to solution
Rémi M.
Level 1
Level 1

‎05-24-2018 04:11 AM - edited ‎07-05-2021 08:40 AM

Hi,

I try to enable ClientLink in some AP 1700 autonomous with the CLI command : beamform ofdm .

There seems to be no effect . Nothing in the running-config and the same with sh controllers dot11Radio 0 | i Beam .
Is it possible to enable ClientLink in some AP 1700 ?

How it works beamforming in a AP 1700 ?

Is there something to enable ?

Thanks, best regards

Labels:
0 Helpful
1 Accepted Solution

Accepted Solutions
1 Reply 1

Go to solution
Evan Wheatley
Level 1
Level 1

‎05-30-2018 12:26 PM

As far as I'm aware, the 1700 doesn't support ClientLink.

 

https://www.cisco.com/c/en/us/products/collateral/wireless/aironet-1700-series/datasheet-c78-732347.html

 

 

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card