AP 1850 dropping out

[DipamPatel4665]

Hello,

I am new to Cisco and had been given 3 of the AP 1850's to setup. I understand the first one that is setup becomes the controller. The remaining two find it and become the managed units. I successfully managed to get them up and from the Primary, i can also see the other two. 

However, one of the two member AP's keeps on losing connection to the controller on a regular basis and then automatically reconnects. Is this normal behavior?

[Sandeep Choudhary]

No its not a normal behaviour.

Check if you are running the stable version on WLC and also chekc the swicthports where all APs are connected.

Regards

Dont forget to rate helpful posts

[DipamPatel4665]

I shall check the version of the WLC. I have moved it around to different ports, and it displays the same behaviour