AP 2602I OfficeExtend mode

[Nigrofasciatum]

Hi,

I´m trying to deploy APs 2602I in officeextend mode. According the datasheet, this AP support officeextend mode, as 1600, 3600,1700, 2700, 3700 APs series, and the OEAP600 (specially designed for this mode).

The AP has the LWAPP IOS version 152-2.JB1. I can access the graphic http interface and appears "office extend access point" and a "enter" buttom, but when I click the enter button appears an error message "The AP is not in FlexConnect mode". No more options.

Through the CLI, I access to LWAPP IOS commands and options, but I don´t find any option for configure OfficeExtend mode. 

I only obtain documentation for configure OEAP600 AP, but this configuration is not the same for the 2600 AP. The command "config ap mode flexconnect" is not supported on 2600 AP, and aparently no options to enable officextend mode or GUI. 

Some has deploying this scenario, or similar?

Thanks

[Rasika Nayanajith · Accepted solution]

The command "config ap mode flexconnect" is not supported on 2600 AP, and aparently no options to enable officextend mode or GUI. 

This is not AP specific command. It is based on WLC software code, I believe this is supported in 8.x codes onward.

Regarding 2600 to use as office extend, it is configurable via WLC GUI (not directly on AP itself). Refer below for more detail

http://mrncciew.com/2013/01/15/configuring-oeap/

HTH

Rasika

*** Pls rate all useful responses ***