AP aironet 700 not logging in the WLC 4124

[MarioBrocato]

AP: CISCO AIR-CAP702i-A-K9

Running flash: ap1g1-rcvk9w8-mx.152-4.JA I have tried to install a new flash via TFTP but can't it still rejecting the image

WLC: 4124

version 3.2.193.5

I have been trying to make the AP work with the WLC:

the AP is not recognizing the WLC with DHCP, I tried to configure it manually adding the primary controller IP and Name in the AP but still nothing.

I know 700 series uses capwap and only works in layer 3.at the moment the WLC is controlling Aironet 1000 series AP's; so once I changed the WLC to transport LWAPP from layer 2 to layer 3 the old APs stop working.

[Leo Laohoo]

What is the exact firmware version the WLC is running on, 3.2.193.5?  

For the 700 to work, the WLC must be running a minimum of 7.5.102.0.

[MarioBrocato]

updating the firmware will make the old APs 1020 stop working?

[Leo Laohoo · Accepted solution]

updating the firmware will make the old APs 1020 stop working?

Correct. 

The final software support for the 4400 is 7.0.X.  So this means that the 4400 cannot support the AP702.

However, the AP702 can be run using Autonomous IOS.

[MarioBrocato]

I'm trying to get the Autonomous Image but the web is asking for a service contract :/ it's the first time I need one of those.

[Leo Laohoo]

Just want to say "thanks" for taking the time to rate our posts.  :)

[Sandeep Choudhary]

Hi,

 AIR-CAP702i-A-K9 : it require 7.5.102.0 SW version on WLC to join.

You need to upgrade it.

Check the compatibility matrix:

http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

REgards

Dont forget to rate helpful posts