AP MAC adresses in flexconnect group configuration not showing the cli config file

[Niels Marien]

Dear,

Could someone please check and verify of this is normal.

When I export the config from the GUI or CLI, I don't see the which AP are listed under which Flexconnect group.

I need to have this information to automatically update the config on the N + 1 redundancy controller.

Now I have to visually check every Flexconnect group and then copy past the mac of the AP to the other controller…. ☹

Kr

Niels

[superego]

What command did you use to show the running config in CLI?

Try:

***for the full running config***

show run-config commands 

***for flexconnect config***

grep include "flexconnect group" 'show run-config commands'

***Please mark this as an acceptable solution if it helped.  Thanks.***

[Niels Marien]

There is a part of the flexconnect config, but no AP's mac.
Is there in your setup? Because that was the question in the tread.

[omz · Accepted solution]

Hi

WC01) >show run-config commands

...
flexconnect group 00027A add
flexconnect group 00027A ap add 34:db:fd:xx:xx:xx
flexconnect group 00027A ap add 34:db:fd:xx:xx:xx
flexconnect group 00027A radius ap server-key <hidden>
...

Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 8.0.152.0

Can see the AP MAC in flexconnect config.