12-22-2010 03:32 AM - edited 07-03-2021 07:34 PM
i configured wism to support(cisco AIR-AP1231G-A-K9,cisco AIR-LAP1252AG-A-K9) in one buliding in my enviroment .
now i put all AP in vlan 220 , wireless users in Vlan 192 as our standard
the probelm 1231 AP take IP from DHCP pool and working fine
but 1252 not take IP from wism.
please help me
12-22-2010 03:35 AM
Where is the POOL for both 1231 and 1252??
Regards
Surendra
12-22-2010 04:45 AM
on Cisco Core 6513 in DHCP Pool in vlan 220 (AP Mangement)
and All interfaces for vlan are UP
12-22-2010 05:02 AM
If a 1252 that is on the same switch and same vlan as a 1230 and is not getting an ip address, this is very suspicious.
Please post the configuration of your DHCP pool (configured option 60 by any chance ?) and switchports.
Please also check the console of a 1252 booting.
Hope this helps.
Nicolas
===
don't forget to rate answers that you find useful
12-24-2010 10:57 PM
ip dhcp pool Mang_AP
network 10.1xx.220.0 255.255.254.0
default-router 10.1xx.220.10
option 43 hex ********************
option 60 ascii "Cisco AP c1250"
==>Now All 1230 AP in vlan 220 and working fine
but i have problem in 1252 AP in vlan 220 not getting IP form DHCP in VLAN 220
regards
12-25-2010 07:19 AM
If you put 2 different AP models (1230 and 1250) in the same subnet, you need to remove option 60.
As far as I'm concerned, I consider the option 60 totally useless.
Hope this helps:
Nicolas
===
Don't forget to rate answers that you find useful
12-25-2010 09:28 PM
1230 work but not the 1250.
Let me ask the basic question: What is the firmware of the WiSM?
12-25-2010 11:21 PM
thanks for all
Software Version6.0.182.0
after remove option 60 from DHCP still the problem !!!!!!!!!!!!!!!!!!!!!!
this is from wism (sh wism status)
WLAN
Slot Controller Service IP Management IP SW Version Status
----+-----------+----------------+----------------+-----------+---------------
9 1 10.1xx.219.251 10.1xx.220.251 6.0.182.0 Oper-Up
9 2 10.1xx.219.252 10.1xx.220.252 6.0.182.0 Oper-Up
thnaks again
05-29-2011 07:04 AM
Hi,
Please mark the Question as Answered if the provided information is correct and issue is fixed.
thanks,
Vinay
12-26-2010 02:59 AM
Console into the 1250 AP and then reboot this AP. Post everything starting from the bootup up.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide