cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
780
Views
5
Helpful
5
Replies

AP2800/3800 dual 5GHz feature

I want to know whether we can deployment one 5GHz for one SSID? Are the functions mentioned below implemented now? If it can be achieved, does anyone know how to deploy? Thank you

 

i have read the cisco doc on Release 8.3

Currently both Macro (green) and Micro (yellow) cells use the same SSID by design; later releases will likely allow for different SSIDs

 

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-3/b_cisco_aironet_series_2800_3800_access_point_deployment_guide/b_cisco_aironet_series_2800_3800_access_point_deployment_guide_chapter_01001.html

 

 

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !
5 Replies 5

Scott Fella
Hall of Fame
Hall of Fame

That is not the intended way to implement that feature.  I also don't see any good use cases for that.  With any features, you need to look at the configuration guide like what you have done.  You just need to look at other newer versions to see if its available or not.  Take a look at the 8.10.x

You would look here if its defined, if not, then its not supported:

Cisco Wireless Controller Configuration Guide, Release 8.10 - Radio Resource Management [Cisco Wireless LAN Controller Software] - Cisco

-Scott
*** Please rate helpful posts ***

Yes, as you said, I tried to find it too, but I didn’t find it. Maybe it’s still not supported right now.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

Any Comments ?

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !

If you didn’t find it and you don’t see it in the configuration of the ap, then it’s not supported. Again, I don’t see why anyone would do that. In an enterprise, you would introduce coverage gaps. Your best bet is to have higher density and allow the macro and micro radios to have the same ssid.
-Scott
*** Please rate helpful posts ***

Yes, I will not do this, I just want to confirm whether this supports this feature and whether anyone has tried it. Every time you answer, thank you very much for your help.

~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Rps-Cheers | If it solves your problem, please mark as answer. Thanks !
Review Cisco Networking for a $25 gift card