AP350 and transmit power

[a.diot]

I can't configure a transmit power of 100mW on my AP350,max is 50mw

I've installed firmware 11.23T (radio 4.25g) no change

Did i forget something somewhere to validate this transmit power?

Thanks

Alain

[jorge_lopez]

When adquiring AP's in the ETSI ZOne, the higher output power you can use is 50 mW, to avoid using higher EIRP than the allowed by ETSI. If you had an US device, you could use this 100 mW configuration. Somewhere in the device you'll find a label telling it's and etsi device (typical German)

[fbehra]

It is possible to modifiy an ETSI AP350 to deliver 100mW ?

Or the two modeles (US and ETSI) have different hardware ?

Thanks for answering

--

Franck

[pelms]

Maximum output power on the 350 is 50mW (17dBm) however it is normal to use antennas of approximately 2-3dB gain which then takes you up to maximum isotropic output power of 100mW (20dBm). (17 + 3 =20dBm).