03-01-2017 06:38 AM - edited 07-05-2021 06:38 AM
Hi,
I have controller and the access point are on the subnet. Due to some requirement i want to statically add the access point ip address and controller ip address into the AP. Kindly suggest me the suitable commands for this.
i used the following commands.
capwap ap ip address 1.1.1.2 255.0.0.0
capwap controller 1.1.1.1
is this commands correct ?
kindly help me in that
03-01-2017 12:08 PM
Wait for the AP to join the controller and change the IP address using the GUI. Simple.
03-02-2017 04:22 AM
ok Leo, what if we want to change the access point back to dhcp mode so that it automatically discover the controller.
can you help me in that
thanks
03-02-2017 12:03 PM
what if we want to change the access point back to dhcp mode so that it automatically discover the controller.
Again, use the GUI.
03-02-2017 12:58 AM
Hi,
for controller IP address it is command "capwap ap controller ip address..."
for AP IP address you have correct command.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide