cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
373
Views
0
Helpful
1
Replies

Autonomous to LWAP

Shabeer E
Beginner
Beginner

Dear Gents

I'm using WLC 5508 software ver: 7.4.110.0, would like to convert below automous AP to LWAP. I'm not sure this model of AP support

WLC 7.4 code. Kindly advise any possibilites to get it work with WLC.

AIR-SAP1602I-E-K9

AIR-AP1142N-E-K9

AIR-AP1230B-E-K9

Thanks..

1 Accepted Solution

Accepted Solutions

Stephen Rodriguez
Cisco Employee
Cisco Employee

the 1230 is the only one that won't work

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn74.html#wp1048617

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

View solution in original post

1 Reply 1

Stephen Rodriguez
Cisco Employee
Cisco Employee

the 1230 is the only one that won't work

http://www.cisco.com/en/US/docs/wireless/controller/release/notes/crn74.html#wp1048617

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers