Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

Resolved! AP Alert

What is the meaning of this Alert as extracted from Cisco Prime Infrastructure.Message: Interference threshold violation reported by '802.11b/g/n' interface of AP 'XXX', connected to Controller 'XXX'.

collrbbrt by Level 1
  • 120 Views
  • 1 replies
  • 0 Helpful votes

Hi Do 9100 series APs support remote LAN as OEAP? Which model do support OEAP? Any guide on how to configure?

Moudar by VIP
  • 175 Views
  • 5 replies
  • 0 Helpful votes

Hi I've received complaints from several users regarding Teams meetings where the voice lags behind the video. One of the checks I conducted was to ping the gateway that terminates at the WLC:     Reply from 10.2.48.1: bytes=32 time=10ms TTL=255 Repl...

Moudar by VIP
  • 162 Views
  • 3 replies
  • 1 Helpful votes

Hi all,I am new to wireless technology and would like to know more about the basic concepts, common issues, troubleshooting steps etc. Where can I find relevant documents or videos to enhance my knowledge in it?

gija by Level 1
  • 121 Views
  • 1 replies
  • 0 Helpful votes

Hello to everybody, we would like to share with you some problems we have raised in our wifi infrastructure. The subject is  the client roaming from an AP to another. We wish you can have some suggestions to solve the roaming issues described below. ...

Hi all,How can I find out the certificate expiration date of an AP 3702? I have seen the 'show crypto pki certificates' command in various forums but in the case of my AP it does not recognize that command.Thank you very much

Aleck_Sei by Level 1
  • 718 Views
  • 5 replies
  • 0 Helpful votes

Hello all , I just purchased a handful of 3702i aironet AP’s and am trying to get ahold of software , but I am trying to use these at my house , I am teaching myself and building a home lab , I do not have the means to obtain a service account , as I...

Resolved! Cisco AP stby 9115

I would like to operate 2 products of cisco ap 9115. You set the virtual controller IP for the two APs to XXX.XXX.XXX.232. IP was set to 233 and 234 respectively as an Access Point. If you boot after setting it up like this, one AP will ...

heyjunsun by Level 1
  • 387 Views
  • 8 replies
  • 0 Helpful votes

Hi,We have a pair of 9800s in HA/SSO. About to migrate our APs from 8540 to 9800. As im recreating our SSIDs to the new 9800s, we cant get the one flexconnect SSID to work. The 4 centrally switched SSIDs work as expected. I have followed the various ...

trondaker by Level 1
  • 368 Views
  • 6 replies
  • 0 Helpful votes

Hello.We are in the process of moving a bunch of access points from an old supplier to us as a new supplier.The old supplier does have a WLC which "holds" all of the access points.I set up a new 9800 WLC, and tried to move one of the access points to...

Jorgenw007 by Level 1
  • 2711 Views
  • 19 replies
  • 0 Helpful votes

I got problem with my AP, here is the log please help me.BootROM - 1.78Booting from SPI flash, Secure modeBootROM: RSA Public key verification PASSEDBootROM: CSK block signature verification PASSEDBootROM: Boot header signature verification PASSEDBoo...