Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Labels

Forum Posts

We are merging with another company and as a temporary solution until we can fully merge into one company we are going to run 2 completely separate wireless networks. Currently the offices are running a full Meraki wireless solution. We are going to ...

Hi GuysI am looking for WIFI 6E access points for a new installation, we may need some patch/sector antennas where we have certain coverage required.We use Meraki and so I am looking at the CW9164 indoor AP and for outdoor I am looking at the CW9163E...

Tenemos una infraestructura con Catalyst 9407 y Meraki MR56 y MR46.  Existe un sintoma en el cual algunos AP caen y hemos detectado en el Switch flapeos de la interfaz. Esto se da de forma aleatoria en cuanto equipo, fecha y hora, no existe un patron...

MarioOG by Level 1
  • 243 Views
  • 3 replies
  • 0 Helpful votes

I need to setup a 2.4GHz Band Only for IoT devices. I saw a previous post that support needs to enable that option since I am having a hard time locate the feature in web app.I submitted a support ticket through Meraki portal but can't see any ticket...

VinnieSJ by Level 1
  • 224 Views
  • 2 replies
  • 0 Helpful votes

Hi, i have at a customer site one WLAN based on Meraki. Three SSIDs are configured: two corporate and one for guests. for the three SSIDs the authentication/authorization policies are enforced by the ISE (v3.3). The users attempting to get access to ...

fcagica_0-1704999453993.png
f-cagica by Level 1
  • 280 Views
  • 2 replies
  • 0 Helpful votes

Hello all, I am very new to using the Meraki GUI and networking in general. I have been tasked with creating a new SSID for a site. This SSID needs to have access to the local DNS server at the site so they can access a proprietary webapp, internet a...

mrand67 by Level 1
  • 219 Views
  • 3 replies
  • 0 Helpful votes

We are running Cisco Meraki APs that are connected to a Catalyst 9410 switch and are experiencing and issue with roaming. We put in the 9410 switch last week replacing a 4510. We did not have this issue when the same Meraki APs were connected to the ...

tbduff001 by Level 1
  • 397 Views
  • 4 replies
  • 0 Helpful votes

Hi, I was trying to run just plain simulation of Signal Coverage patterns on Ekahau for CW9166 and MR57 and match the propagation patterns with Datasheets just to see how good they are when being compared to datasheet Coverage patterns. Please note ,...

MohWaqasWiFi_0-1700406771335.png

Has anyone performed any recent Meraki access points firmware upgrades?  We have been told not to perform the last few because they would impact client roaming which is critical.  It seems odd that Meraki has produced the last few firmware updates (2...

mlreboli1 by Level 1
  • 1026 Views
  • 4 replies
  • 1 Helpful votes
Review Cisco Networking products for a $25 gift card