Bridge link with two aironet 1242

[uosambela]

                   Hi to all,

I want to connect with wireless devices two buildings, one in front of another.

Short distance (about 20 meters) and no obstacles.

I have a couple of aironet 1242 and i was wondering if it would be possible to setup this link with this equipment.

could  WGB be the solution?

thank you very much

[kcnajaf]

Hi,

Yes you could use WGB configurations in order to achive your goal. Please refer the documentation below which details how to set up WGB.

http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_example09186a00805b9b87.shtml

Hope this helps

Regards

Najaf

Please rate when applicable or helpful!!!

[Stephen Rodriguez]

WGB could work, if you do not need to extend multiple VLAN across the link, and you have less than, I want to say 200, devices.

What you might want to look into is Root/ non-Root bridging.

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008058f53e.shtml

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered