cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
488
Views
5
Helpful
2
Replies
Jeremy Dubrulle
Beginner

Broadcast forwarding WLC 9800

Hello,

 

I have a need to enable broadcast on a specific SSID with 9800 WLC.

I know it's impossible with old WLC but is it possible with 9800 ?

 

Is there a way to enable this only on specific AP with flexconnect for example ?

 

My goal is to avoid enabling that on the whole WLC.

 

Thanks,

 

Jérémy

2 REPLIES 2
Rasika Nayanajith
VIP Mentor

Hi Jeremy,

Pls check the below post on FlexConnect broadcast traffic behavior

https://community.cisco.com/t5/wireless-and-mobility/flexconnect-and-broadcasts/td-p/2044077

 

I do not think you can configure it for specific flex profile. It is a global config

 

HTH

Rasika

*** Pls rate all useful responses ***

Hello Rasika,

 

Thanks for your help.

 

For flexconnect that's a good piece of information.

 

Anyway I've found since I created the topic this doc : https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/cmd-ref/b_wl_16_10_cr/configuration-commands-g-to-z.html#wp7625205920

 

It explains that To enable broadcast support on a VLAN, use the wireless broadcast vlan command in global configuration mode. To disable Ethernet broadcast support, use the no form of the command.

Content for Community-Ad