10-27-2019 08:41 PM - edited 07-05-2021 11:12 AM
Why can't the AP boot with new image. How should I do?
Thank you very much
10-27-2019 09:10 PM
10-27-2019 09:34 PM
10-27-2019 09:41 PM - edited 10-27-2019 09:57 PM
Two options:
1. RMA the AP; or
2. Contact Cisco TAC and they will provide assistance and instruction on how to load the firmware via console (will take <50 minutes).
10-27-2019 09:46 PM
had same thing happen to a 2800 AP had to RMA the AP
10-27-2019 10:18 PM - edited 10-27-2019 10:19 PM
I downgrade the firmware and there are other 2 APs happen the same.
Thank you very much.
10-27-2019 10:27 PM
10-27-2019 10:34 PM
10-28-2019 12:40 AM
10-28-2019 01:35 AM
10-28-2019 02:35 AM
10-27-2019 10:28 PM
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: