The C9105AXW access point has got 3x 10/100/1000 Base-T (Ethernet) Downlink Interface (LAN1,LAN2 and LAN3).
How do you configure those downlink interfaces in Mobility Express?
Can you assign each interface to a different VLAN?
Any link to Cisco information about that?
Thank you very much.
And with EWC?
I understand this AP is similar to AIR-AP1810W, which has got downlink LAN ports too (or Cisco OfficeExtend access point (OEAP) )
Check this guide, I hope it also works with EWC.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: