cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2266
Views
0
Helpful
3
Replies

C9800 break HA to standalone controller

Charlie Grey
Level 1
Level 1

running 17.3.6 on C9800.

i attempt the do the above but unsuccessful.

check online Cisco Doc - 17.3.x - disable HA.

Disabling High Availability

If the controller is configured using RMI method, use the following command:

no redun-management interface vlan chassis <<<<<<<<<

i configure HA using RMI.

the CLI command (in bold) to break the HA-SSO dont exist!!!

Any idea how to break HA for 17.3.x???

thanks.

 

 

1 Accepted Solution

Accepted Solutions

Charlie Grey
Level 1
Level 1

thanks for all the suggesstion.

i hit into a bug - CSCvu80893.

View solution in original post

3 Replies 3

marce1000
VIP
VIP

 

 - Try various command completion directives with the ?-mark ending subsequence of the command to find correct way of completing the command.

 M.



-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
    When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '

balaji.bandi
Hall of Fame
Hall of Fame

The easy method i can think of is :

1. turn off the Standby controller 

2  From Active GUI administration --> device --> REdundancy --> disable.

Note: suggest taking the configuration backup, check which one is active and which standby 

#show redundancy

#show chasis

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Charlie Grey
Level 1
Level 1

thanks for all the suggesstion.

i hit into a bug - CSCvu80893.

Review Cisco Networking for a $25 gift card