C9800 break HA to standalone controller

[Charlie Grey]

running 17.3.6 on C9800.

i attempt the do the above but unsuccessful.

check online Cisco Doc - 17.3.x - disable HA.

Disabling High Availability

If the controller is configured using RMI method, use the following command:

no redun-management interface vlan chassis <<<<<<<<<

i configure HA using RMI.

the CLI command (in bold) to break the HA-SSO dont exist!!!

Any idea how to break HA for 17.3.x???

thanks.

[marce1000]

 - Try various command completion directives with the ?-mark ending subsequence of the command to find correct way of completing the command.

 M.

[balaji.bandi]

The easy method i can think of is :

1. turn off the Standby controller 

2  From Active GUI administration --> device --> REdundancy --> disable.

Note: suggest taking the configuration backup, check which one is active and which standby 

#show redundancy

#show chasis

[Charlie Grey · Accepted solution]

thanks for all the suggesstion.

i hit into a bug - CSCvu80893.