cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
392
Views
0
Helpful
3
Replies

C9800 break HA to standalone controller

Charlie Grey
Beginner
Beginner

running 17.3.6 on C9800.

i attempt the do the above but unsuccessful.

check online Cisco Doc - 17.3.x - disable HA.

Disabling High Availability

If the controller is configured using RMI method, use the following command:

no redun-management interface vlan chassis <<<<<<<<<

i configure HA using RMI.

the CLI command (in bold) to break the HA-SSO dont exist!!!

Any idea how to break HA for 17.3.x???

thanks.

 

 

1 Accepted Solution

Accepted Solutions

Charlie Grey
Beginner
Beginner

thanks for all the suggesstion.

i hit into a bug - CSCvu80893.

View solution in original post

3 Replies 3

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - Try various command completion directives with the ?-mark ending subsequence of the command to find correct way of completing the command.

 M.



-- ' A nun once asked a penguin ' do you think the earth is flat ? ; the penguin replied :
Madam, it all depends , in Riemann geometries the earth can be perfectly flat! The nun thanked him , he tripped and fell forward : the poor animal had forgotten that he might be living in a Riemann geometry too!

balaji.bandi
VIP Community Legend VIP Community Legend
VIP Community Legend

The easy method i can think of is :

1. turn off the Standby controller 

2  From Active GUI administration --> device --> REdundancy --> disable.

Note: suggest taking the configuration backup, check which one is active and which standby 

#show redundancy

#show chasis

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Charlie Grey
Beginner
Beginner

thanks for all the suggesstion.

i hit into a bug - CSCvu80893.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers