cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
975
Views
0
Helpful
3
Replies

Can a Flexconnect (h-reap) survive reload while in standalone mode

sin
Level 1
Level 1

I have searched and asked round for this the last weeks. Can't find the answer.

When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?

Is it possible to make a setup with i.e. WPA/PSK where the AP keeps working after a reload in standalone mode ?

Chears

Rasmus

3 Replies 3

Leo Laohoo
Hall of Fame
Hall of Fame
When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?

When your WAN link(s) goes down and your FlexConnect (H-REAP) WAP reboots, it will not service anything/anyone.

Thanks. That was what I inspected but could not find any documentation for it.

Saravanan Lakshmanan
Cisco Employee
Cisco Employee

After reboot it is expected that hreap/flexconnect AP to retain the config and serve local clients, if it is not doing so then it is broken. However, this behavior is not documented in cco.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: