Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
799
Views
0
Helpful
1
Replies

Can't enable EAP or LEAP on client

dstuben
Level 1
Level 1

‎09-26-2001 05:44 AM - edited ‎07-05-2021 12:03 PM

Can anyone tell me what I am doing wrong?? I have a 340 Access Point running IOS 11.7 and radio firmware 4.25 and have Draft 10 enabled. On the client I have a Cisco 340 PCI card and the same radio firmware and version 6.97 of the NDIS driver and I am using Windows 98 SE. Using the client utilites version 4.15.006, I can't enable LEAP or EAP on the client, it is greyed out. Am I missing something? I am using the beta code from Funk Software for LEAP as my RADIUS server. Any help would be greatly appreciated!!!

Labels:
0 Helpful
1 Reply 1

dstuben
Level 1
Level 1

‎09-26-2001 09:03 AM

FIXED. Had to go back and uninstall the ACU software. At that point I was able to reconfigure the utility to use LEAP. I have had the software on my laptop for a long time and forgot that that was an option when initially installing the software. Now onto getting the Access Point and RADIUS server talking properly....

0 Helpful
Customers Also Viewed These Support Documents
Review Cisco Networking for a $25 gift card