Can't schedule SSIDs on and off- only APs in NCS?

[lbadman]

Can I get a sanity check? It appears that through NCS, you cannot create a template that eneables and disables an individual WLAN- only APs?

[Stephen Rodriguez]

Lee,

     Go to Configure > Controller > Select WLC > WLAN > WLAN Conifguration

check the box next to the WLAN, then in the drop down select scheduled task.

Then go to Configure > Scheduled Configuration Tasks.  From there you should be able to set the enable/disable

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

[lbadman]

Wowsa- thanks Steve. I never would have found that, was glued to the config template area. This has been a bit of a white whale, and wasn't seeing it in help docs. You've made my day!

-Lee

[Stephen Rodriguez]

No worries.  They kinda buried it down in the weeds

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered