cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
744
Views
0
Helpful
5
Replies
Highlighted

Can you config a AIR-LAP1262N-T-K9 as a stand alone?

Hi guys, i try to configure this equippament for use wi-fi , but i dont know how change a original mode for a stand alone.

any body knows how to solve this?

5 REPLIES 5
Highlighted
Contributor

Hello.

You must change firmware from LAP to Autonomous, You must have tftp server. I use FreeBSD with alias on interface 10.0.0.2 , then press MODE button and connect power to AP. And view message on console , and view log on TFTP server. Your AP try to get xxx.default firmware from TFTP. Rename autonomous firmware to this and put it to TFTP and try to upgrade again

--------------------------------------------------------------------------

Helping seriously ill children, all together. All information about this, is posted on my blog
Highlighted
VIP Expert

here is good guide convert to Autonomous mode :

 

https://mrncciew.com/2013/12/13/ap-conversion-using-mode-button/



BB


*** Rate All Helpful Responses ***

Highlighted
Hall of Fame Master

I think the issue is you might not be able to download the autonomous image. You have to have a valid support contract to access the download for specific devices. Like the others mention, just search for the following and you will find videos, etc on how to do it.

convert lightweight to autonomous
-Scott
*** Please rate helpful posts ***
Highlighted

good morning ,yeah, how do i take this contract? because the product support is over and hes dont give me the firmware.

does If i take contract they give me an archive?

Highlighted

contact local cisco partners to help you with the contract or smartnet contract.



BB


*** Rate All Helpful Responses ***

Content for Community-Ad