Cannot console to AIR-LAP 1252

[MichaelQwerty]

Hello everybody,

Yesterday I got AL 1252 with AC/DC Adapter. Unfortunately I cannot log in to console. There is no output in Putty (sometimes after sevral minutes clicking ENTER there is sth like this:"ţţţţţîţîđîîîţđO˙Ŕ÷÷ířě". AP looks fine, after couple of second Status led is constatnly green which means "Normal operating condition, but no wireless client devices are associated with the unit." (source:

http://www.cisco.com/en/US/docs/wireless/access_point/1250/installation/guide/125h_c4.html)

What shall I do to log in to console?

[Surendra BG]

Use the hyperterminal... and set the baud rated and all top restore defaults. and then try to access..

Regards

Surendra

[MichaelQwerty]

Nope, exactly the same situation - but there was a sign 'x' after a minute pressing ENTER Nothing else

[Surendra BG]

Hmmm... If the Device is under warranty or under contract please open up a TAC case with us and we will see if its the HW failure, then we will replace the device!!

Regards

Surendra

[MichaelQwerty]

I have dealt with this problem once again today.

It shows up that the problem is... my USB-Serial Adapter. I could log in into Cisco routers and switches but not APs! Then I have used USB-Serial Adapter with ProLific chipset and it has worked. It did not concern my computer because my collegues also had the same issue using my adapter.