cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
769
Views
15
Helpful
3
Replies

Catalyst 9800-L failes to respond to IW6300 capwap discovery request

Nanook
Level 1
Level 1

I cannot get my catalyst 9800-L to respond to the IW6300 AP's discovery request.  the IP addresses are fine and I can ping the access point and the controller, and I can see the CAPWAP packets with Wireshark come to the controller, but the controller doesn't respond.  It just sits there with no errors.   Where should be looking for errors.

1 Accepted Solution

Accepted Solutions

Grendizer
Cisco Employee
Cisco Employee

Compatibility Matrix Doc has been updated to reflect the first supported 9800 release for this AP https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html#56735

 

View solution in original post

3 Replies 3

marce1000
VIP
VIP

 

 - Check if both platforms are compatible :

              https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

 M.



-- ' 'Good body every evening' ' this sentence was once spotted on a logo at the entrance of a Weight Watchers Club !

Grendizer
Cisco Employee
Cisco Employee

The support on 9800 WLCs for this AP starts on 17.1 but this release is deferred so try to install 17.3.2a.

I will try to ping the writers of the Compatibility Matrix Doc to update it.

Grendizer
Cisco Employee
Cisco Employee

Compatibility Matrix Doc has been updated to reflect the first supported 9800 release for this AP https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html#56735

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: