After adding a 9800-CL to Prime I got a critical alarm. Does somebody know the reason for this?
Catalyst 9800 Telemetry coral connection failure for device IP 10.1.51.11. Please check the coral connection.
I have the same problem.
device packs are not available
to my infrastructure, I have a fresh installation of cisco prime infra. 3.6 und the cisco wlc 9800 16.10.01e (recommanded by cisco)
thanks and regards..
Same here with
"Catalyst 9800 Telemetry coral connection
failure for device IP x.x.x.x. Please
check the coral connection."
Prime Infr. Build 184.108.40.206.310, PI 3.8 Update 02, Prime Infrastructure 3.8 Device Pack 1
Controller listed in Prime but were are no APs from that wlc.
For 17.3 you need PI 3.8MR1 - as documented on the release notes
We have a EFT image we can give you. You can contact your account manager to sign you in or open a TAC SR so we can give you the link.
Thank you for reply,
after my post, we've seen in
, too, that we have to wait for MR1 release. Could you mention a release date for the MR1?
with 3.8.1 MR1 (installed in September) everything runs fine in our installation. Controller and APs shown in Prime.
Thx and Regards.