Change from [Autonomous Mode] to [Lightweight Mode]

[akirat001]

I used Aironet1700 [AIR-CAP1702I-Q-K9].

I changed [Autonomous Mode] by <capwap ap autonomous> command.

But I want to return [Lightweight Mode].

Please tell me how can I do.

[Sandeep Choudhary]

Hi,

Paste the output of this command:

sh version from AP.

Please check these posts to convert AAP to LAP.

https://mrncciew.com/2012/10/20/lightweight-to-autonomous-conversion/

https://www.youtube.com/watch?v=wWDrFjwVNb0

https://www.youtube.com/watch?v=Fiv76UpStKI

Regards

Dont forget to rate helpful posts

[akirat001]

Hello.

Thank you for your advice.

I found this url and tried them.
As a result, we were able to change.

http://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_01101010.html

Regards

[Sandeep Choudhary]

Hi,

Did my post solved your problem then please mark this question as answered. It may help others.

Regards

Dont forget to rate helpful posts

[mohanak]

Refer link : http://www.cisco.com/c/en/us/td/docs/wireless/controller/8-0/configuration-guide/b_cg80/b_cg80_chapter_01101010.html