08-10-2020 09:27 AM - edited 07-05-2021 12:23 PM
Hello,
I have a pair of 5508 WLC setup in HA mode. What is the best way to change the IP addresses of the management and redundancy management interfaces on BOTH 5508 WLC? I also need to change IP addresses of all the WAPs too. Are there any pitfalls I am missing here?
08-10-2020 09:44 AM
you need to break HA.. changes the IP addresses and set HA again.
If AP were manually set with an IP address then you need to re-do that manually. If there are too many you might want to run a script to do that for you.
The WLANpoller might be helpful with that: https://developer.cisco.com/docs/wireless-troubleshooting-tools/#!wlan-poller-wlan-poller/wlan-poller
08-10-2020 09:48 AM
Is this what you are saying? please include the commands to perform these changes
1. Disable HA
2. Console into active WLC and change IP
3. Console into passive WLC and change IP
4 Enable HA
08-10-2020 10:28 AM
you can check how to disable HA in the following link
08-10-2020 11:32 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide