03-20-2023 01:08 PM
Hi Cannot change dhcp ip starting and ending ip address. I want to change starting ip address and ending ip address. After changing it to make the range smaller, and click on Update & Save to Device successfully. however, when click on the new created dhcp server, I can the original starting and ending ip address are still there. Why it happen? Thanks
Solved! Go to Solution.
03-20-2023 03:00 PM
Not sure i am not able to simulate the issue on WLC 9800 :
try command level :
03-21-2023 12:58 AM
- Look at impact of your commands by taking diffs on the running-config (before after ->with the CLI) , then subsequent use of the CLI and changing running config 'manually' (not with GUI) , may be easier to achieve what you need ,
M.
03-20-2023 03:00 PM
Not sure i am not able to simulate the issue on WLC 9800 :
try command level :
03-21-2023 12:58 AM
- Look at impact of your commands by taking diffs on the running-config (before after ->with the CLI) , then subsequent use of the CLI and changing running config 'manually' (not with GUI) , may be easier to achieve what you need ,
M.
03-21-2023 06:37 AM
Thank you!
03-21-2023 10:42 AM - edited 03-21-2023 10:44 AM
I've just tested on 17.9.3 and when I change it then Update and Apply it works correctly so the question is what version are you using? It might also be a browser issue.
You're a regular poster so you should know by now to quote the model and software version you're working with.
Personally I would just use CLI to configure DHCP - quicker and easier and simpler.
03-21-2023 02:16 PM
@Rich R you are right. and I agree with you. this should not be a problem. My version is 17.9.2. I also do not think it is software issue. The reason why i brought the question is to further confirm my thought and find if there is other issue. Thanks
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide