Hi all,
I have just procured a 140AC at one of our remote office. It is has an RV345P installed which is convenient. The device is plugged in and configured with an IP address. I can VPN into the office, but I can contact the device, the port 22 and port 80 is showing up with nmap, but any connection to port 80 is rejected (port shows up closed). We have done a factory reset of the device, but it does not seem to be making any difference (to access it).
I now suspect that the initial setup must be done through WiFi only? I have tried to ssh into it, it responds, but any guessing on the username and default password has failed.
Anyone?
Best,
008
