Hi Cisco Team,
Can you help me on to convert the Cisco 2702 to Autonomous mode.
So far i already did some config on the AP.
Pls see below :
Light Weight to Autnomous CLI Commmands :
-set ENABLE_BREAK yes
-set IP_ADDR 192.168.0.1
-set NETMASK 255.255.255.0
-tftp_init
-ether_init
-flash_init
-tar -xtract tftp://192.168.0.2/ap3g2-k9w7-tar.153-3.JD3.tar flash:
After Uploading the image files this is the next command:
-set BOOT flash://ap3g2-k9w7-mx.153-3.JD3/ap3g2-k9w7-mx.153-3.JD3
-boot
Unfrotunately after boot it says error boot no image found.
Thanks
Marlon
