07-20-2013 09:35 AM - edited 07-04-2021 12:28 AM
Anyone ever seen this problem?
not working 3600e(config-if)#power local ?
<2 - 2> One of: 2
maximum Set power to allowed maximum
Instead of
working 3600e(config-if)#power local ?
<2 - 23> One of: 23 20 17 14 11 8 5 2
maximum Set power to allowed maximum
CCNP - Wireless
CWNA and CWAP
07-20-2013 09:51 AM
Have you tried to set the antenna gain first then see if the allowed power is available.
Sent from Cisco Technical Support iPhone App
07-20-2013 09:59 AM
yeah, I have also defaulted the AP. no luck. Power on the switch port shows 15.4 also
CCNP - Wireless
CWNA and CWAP
07-20-2013 10:07 AM
From show controller d1
Configured TxPower: -4 dBm
Allowed Power Levels: -4 dBm
Allowed Client Power Levels: -4 dBm
Active Rates:
CCNP - Wireless
CWNA and CWAP
07-20-2013 10:16 AM
What does this show when you issue the command:
show controllers dot11radio 0
show controllers dot11radio 1
Never mind... Didn't see your other post
Sent from Cisco Technical Support iPhone App
07-20-2013 10:18 AM
You see this on d0 also, -4 just means 40 MHz.
Sent from Cisco Technical Support iPhone App
07-20-2013 10:46 AM
I openned a tac case. The eng is saying "that's odd".... never a good sign.
CCNP - Wireless
CWNA and CWAP
07-20-2013 12:20 PM
http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCuf61780
CCNP - Wireless
CWNA and CWAP
07-20-2013 08:46 PM
What is the code running on the AP?
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide