Cisco 5520 and smart licence

[akram.root]

Hello ,

I hope you are doing well.

Could you help me please !

I would sak you what are the port needed on cicso WLC 5520 to communicate a smart licente (direct access via internet ) and which interface used by cisco WLC 5520  to access a internet ?

Best regards

Akram

[balaji.bandi]

Port 80 and 443 is good enough for smart License using Cisco Cloud.

WLC depends on deployment, if you have separate mgmt interface - then I would use that one.

here is the guide how it works :

https://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/8-2/b_Smart_Licensing_Deployment_Guide.html

[akram.root]

Thank you for your reply,

Do you know any commande to test connectivity internet for this page (tools.cisco.com) from WLC 5520.

[Sandeep Choudhary]

1. Find the IP of it by doing nslookup tools.cisco.com

2. try to ping that ip from cisco wlc

Regards

Dont forget to rate helpful posts

[akram.root]

Hello,

Cisco WLC 5520 not support nslookup .

I have another question which interface is used by controller to contact cisco smart licensing ? (Management or SP)

Best regards

[balaji.bandi]

suggest to ping from WLC and try telenet to port 443 see it can, from the same network of WLC.

[Sandeep Choudhary]

Hi Akram,

Controller supports only standard HTTP (TCP 80) and HTTPS (TCP 443) for device registration against SSM.

here is the guide for deployment:

https://www.cisco.com/c/en/us/td/docs/wireless/technology/mesh/8-2/b_Smart_Licensing_Deployment_Guide.html

Regards

Dont forget to rate helpful posts