11-17-2020 05:12 AM - edited 07-05-2021 12:47 PM
Hello ,
I hope you are doing well.
Could you help me please !
I would sak you what are the port needed on cicso WLC 5520 to communicate a smart licente (direct access via internet ) and which interface used by cisco WLC 5520 to access a internet ?
Best regards
Akram
11-17-2020 05:36 AM
Port 80 and 443 is good enough for smart License using Cisco Cloud.
WLC depends on deployment, if you have separate mgmt interface - then I would use that one.
here is the guide how it works :
11-17-2020 06:34 AM
Thank you for your reply,
Do you know any commande to test connectivity internet for this page (tools.cisco.com) from WLC 5520.
11-17-2020 06:45 AM
1. Find the IP of it by doing nslookup tools.cisco.com
2. try to ping that ip from cisco wlc
Regards
Dont forget to rate helpful posts
11-17-2020 08:09 AM
Hello,
Cisco WLC 5520 not support nslookup .
I have another question which interface is used by controller to contact cisco smart licensing ? (Management or SP)
Best regards
11-17-2020 08:49 AM
suggest to ping from WLC and try telenet to port 443 see it can, from the same network of WLC.
11-17-2020 05:39 AM
Hi Akram,
Controller supports only standard HTTP (TCP 80) and HTTPS (TCP 443) for device registration against SSM.
here is the guide for deployment:
Regards
Dont forget to rate helpful posts
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide