02-09-2021 10:31 PM - edited 07-05-2021 01:12 PM
Hi All,
I have two Access points that keep restarting forever, when I connect a console cable I found the following lines.
[*02/05/2021 05:04:30.8873] chpasswd: password for user changed
[*02/05/2021 05:04:36.8354] systemd[1]: wcpd.service failed.
[*02/05/2021 05:04:38.0350] systemd[1]: start request repeated too quickly for wcpd.service
[*02/05/2021 05:04:38.0450] systemd[1]: Failed to start WCPD process.
[*02/05/2021 05:04:38.0450] systemd[1]: wcpd.service failed.
[*02/05/2021 05:04:38.1450]
[*02/05/2021 05:04:38.1450]
[*02/05/2021 05:04:38.1450] Critical process has crashed repeatedly, This will result in reboot of system
[*02/05/2021 05:04:38.1450] You have 20 seconds to run this to stop the reboot. Good luck
[*02/05/2021 05:04:38.1450]
[*02/05/2021 05:04:38.1450] freeze -w
[*02/05/2021 05:04:38.1450]
- It can't join a controller
- it doesn't give me enough time to change the firmware from AP
- I tried to interrupt the boot using ESC and boot via TFTP using the following command, it do upload the bin file to the AP but still not working.
(RNAQ-C7) # tftpboot
any idea please.
Solved! Go to Solution.
08-22-2021 03:36 AM
a hardware issue, the AP replaced with RMA.
02-10-2021 01:51 AM
- Check if the procedures described here can help :
M.
02-10-2021 03:47 AM
what is the version of Code, what WLC controller and what version WLC controller.
may be worth checking is bug is eligible for your environment :
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvp34271/?rfs=iqvred
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCvq65033/?rfs=iqvred
08-22-2021 03:36 AM
a hardware issue, the AP replaced with RMA.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide